#Debrick router router via ssh Patch#

Continue to hold the 'RESET' button while observing the ACT or USR LED upon powerup, it will begin with solid illumination, and then as you hold the button, it will start to blink.keep holding the 'RESET' button until the blinking STOPS (could take 20-30 seconds!!!) and the LED goes dark for a few seconds, then release the 'RESET' button.

Using a pen/unwound paperclip/nail/tack/other thin object, press and hold the 'RESET' button on the back of the RB, and while continuing to hold the button down, apply power to the RB.

#Debrick router router via ssh Patch#

Without applying power to the RB first, connect RB750 ethernet port 1 to computer's ethernet port with any ethernet cable (RB750 and/or most modern computer ethernet interfaces should auto-MDIX even if you aren't using a cross-over patch cable.but if you want some additional 'insurance', you could put a dumb switch in between).Click 'Net booting' button, make sure 'Boot Server enabled' is checked, type in a 'Client IP address' that is within the same subnet as what you set the computer'e ethernet interface to, and click OK.Start Netinstall.exe as Administrator (right-click > 'Run As Administrator.').On the remaining interface/port, disable DHCP client and manually set IP address to whatever (pick something, anything it really doesn't matter).On the computer you are going to use for Netinstall, disable ALL network interfaces (including Wi-Fi) EXCEPT for the ethernet port that you plan to use.

However, for the sake of those here having trouble, I'll try to summarize:

Fairly sure that all of the following information is present in available official documentation.